Automotive vs Deep Cycle Batteries

Small Inverters: Most automobile and marine batteries will provide an ample power supply for 30 to 60 minutes even when the engine is off. Actual time may vary depending on the age and condition of the battery, and the power demand being placed on it by the equipment being operated by the inverter. If you use the inverter while the engine is off, you should start the engine every hour and let it run for 10 minutes to recharge the battery.

500 Watt and larger Inverters: We recommend you use deep cycle (marine or RV) batteries which will give you several hundred complete charge/discharge cycles. If you use the normal vehicle starting batteries they will wear out after about a dozen charge/discharge cycles. If you do not have a deep cycle battery, we recommend that you run the engine of your vehicle when operating the power inverter.

When operating the inverter with a deep cycle battery, start the engine every 30 to 60 minutes and let it run for 10 minutes to recharge the battery.

When the inverter will be operating appliances with high continuous load ratings for extended periods, it is not advisable to power the inverter with the same battery used to power your car or truck. If the car or truck battery is utilized for an extended period, it is possible that the battery voltage may be drained to the point where the battery has insufficient reserve power to start the vehicle. In these cases, it’s a good idea to have an extra deep cycle battery for the inverter (installed close to the inverter), cabled to the starting battery. It is recommended to install a battery isolator between the batteries.

 

---